To use an aerated rubber-based cement and associated press, use this table:
Unroll the adhesive and its backing sheet on a cutting surface,
adhesive side up.
Position image face up on the adhesive and lightly press around the
edges with your hand.
Trim adhesive and backing sheet to edges of the image.
Place the adhesive sheet and image face down on the bedplate.
Cover the item with the bedplate protective cover. If you do not
have a bedplate, cover the item with scrap card stock and burnish
the back with an agate burnisher, rubber roller, or spoon back.
Crank the bedplate handle to move the bedplate between a pair of
Remove the bedplate cover.
Remove the paper backing sheet from the image to expose the
Position the image on the presentation cardstock and repeat steps 4
Continued on next page