Cold press-Cont. - 14066

Illustrator Draftsman 1 & C - Volume 4 Presentation Graphics
Page Navigation
102

Mounting, Continued Cold press (Continued) To use rubber cement or an aerosol rubber cement, use this table: Step Action 1 Cut out the artwork to correct size. 2 Use a nonreproducing blue pencil to lightly mark the position of the artwork on the mounting board. 3 Apply rubber cement or spray adhesive to the face of the mounting board within the area defined by the pencil marks and the back of the artwork. 4 5 Allow the cement to dry. Place a slip sheet of paper or tracing paper over the cement covered surface of the mounting board leaving approximately 1/4-inch exposed at the top. Use two slip sheets when mounting large pieces and slide them out from the center. 6 Position the artwork face up and firmly press against the top (or center). 7 Slowly slide the slip sheet out of the way while smoothing the artwork against the mounting board. Smooth from the center of the artwork to the edges. 8 Place a clean paper or tracing paper over the image and continue to burnish the image into place with an agate burnisher or rubber roller until it is secure. 9 Use a rubber cement pick-up (crepe laytex) to remove excess cement and cement residue. Continued on next page 2-28

Privacy Statement
Press Release
Contact