1-40. The Golden Mean rectangle for compositional formats has what width to height ratio? 1. 2:3 2. 3:5 3. 5:7 4. 8:10 1-41. How should you represent type that is smaller than 12 points in a thumbnail sketch of a textural composition? 1. With upper-case Xs 2. With lower-case Xs 3. With straight lines 4. With shading sheets 1-42. How should you should indicate the colors of ink required for each element of a textural composition? 3.    On  overlays 4. On a separate detail sheet 1. On the back of the comprehensive layout 2. On the borders of the comprehensive layout 1-43. What is another term for mechanicals? 1.    Camera-ready layouts 2.    Paste-up   dummies 3.   Preliminary  dummies 4.    Copy  preparations 1-44. Industry standards for use on blueprints in the military environment are found in what publications? 1.    CAD-CAM 2.   CAD-STDs 3.   ANSI standards 4.   MIL-STDs 1-45. What is the margin dimension on a B-size drawing? 1.   .25 2.   .38 3.   .50 4.   .64 1-46. You should leave how much extra space beyond the right side of a roll-sized drawing as protection for the drawing once rolled? 1.   1  inch 2. 2  inches 3. 3  inches 4. 4  inches 1-47. The vertical margins on an A-size drawing are how wide? 1.    .25 2.    .38 3.    .50 4.    .64 1-48. Where should you locate the title block on master drawings? 1.   Lower-left  corner 2.   Lower-right  corner 3.   Upper-right corner 4.   Upper-left  corner 1-49. Where should the drawing number appear on a master drawing? 1.   The reverse of a rolled drawing only 2.   Lower-right   corner   only 3.   Upper-right  corner  near  the  border only 4.   Lower-right corner of the title block, upper-right corner near the border, and the reverse side of a rolled drawing 5