5-19. What type of projection places the object at an angle to the picture plane while maintaining one set of vertical edges parallel to the picture plane? 1. One-point 2. Two-point 3. Three-point 4. Linear 5-20. Under which of the following circumstances is it possible to take some dimensions directly from a two-point perspective drawing? 1. When the station point is below the object 2. When the station point is on the ground line 3. When one edge of the projection touches the picture plane 4. When the vertical parallel edge is unaffected by station points 5-21. Which of the following attributes is characteristic to oblique perspective? 1. No object surfaces are parallel to the picture plane 2. Height is the only dimension having a vanishing  point 3. Width and depth dimensions have a vanishing  point 4. Height and width have no vanishing points 5-22. What should you do to make small objects appear better in three-point perspective drawings? 1. Place the vanishing points far apart 2. Place the vanishing points close together 3. Place one vanishing point above and two below 4. Place all three vanishing points above the horizon line 5-23. In a one-point perspective drawing using the plan-view method of construction, after drawing the plan view, picture plane, and station point, you should take what step next? 1. Locate the vanishing point 2. Project a vertical line from the station point to the horizon line 3. Project the width of the plan view to the ground line 4. Draw visual rays to the vanishing point 5-24. Where should you find the required information for using the plan-view method of mechanical construction of a perspective drawing? 1. An isometric drawing 2. An  orthographic  drawing 3. NAVSO P-35 4. MIL-STD  110A 5-25. What is the first step in constructing a one- point perspective drawing using the plan- view method? 1. Locate the station point 2. Obtain a depth dimension 3. Draw the plan view 4. Establish a horizon line 5-26. How are the vanishing points located? 1. Extend the vertical lines of the plan view to the ground line 2. Project a ground line parallel to the horizon line 3. Draw the horizon line and drop perpendiculars to the station points 4. Project a vertical line from the station point to the horizon line 5-27. How should you correct distortion in perspective  drawings? 1. Move the ground line 2. Move the horizon line 3. Move the station points 4. Move the cone of visual rays 29