2-13.
2-14.
2-15.
2-16.
2-17.
2-18.
2-19.
Approximately what minimum time
does it take a hand waxer to reach
operating temperature?
1.
5 minutes
2.
10 minutes
3.
15 minutes
4.
20 minutes
A tabletop waxer should be a
minimum of how full before you turn
it on?
1.
1/4 full
2.
1/3 full
3.
1/2 full
4.
2/3 full
Exactly, how many times should you
run a sheet of paper through a
waxer to ensure even coverage?
1.
One
2.
Two
3.
Three
4.
Four
What amount of time should you wait
after changing the temperature
setting on a tabletop waxer before
running your paper through again?
1.
10 minutes
2.
20 minutes
3.
30 minutes
4.
40 minutes
When using a paper cutter,
individuals tend to make what
common mistake?
1.
Cutting film
2.
Cutting cardstock
3.
Cutting too much material
4.
Cutting too little material
You should draw the cutting arm
down on a paper cutter in what
manner?
1.
Slowly in one stroke
2.
Swiftly in one stroke
3.
Swiftly in rapid strokes
4.
Carefully in rapid strokes
Your failure to engage the safety
catch at the base of the paper
cutter will result in damage to
what component?
1.
The spring mechanism
2.
The cutter board
3.
The tabletop
4.
The safety catch
2-20.
A drafting machine combines the
functions of which of the following
pieces of drawing equipment?
1.
Straightedge, scale, and
dividers
2.
Template, T-square, and
straightedge
3.
parallel ruler, protractor, and
triangle
4.
Radius curves, template, and
straightedge
2-21.
You attach the removable scales to
the scale mechanism of a drafting
machine by what means?
1.
Phillips head screws
2.
Dovetail fittings
3.
Elongated screws
4.
Pipe fittings
2-22.
The elongated screws that hold the
dovetail fittings to the scales of
a drafting machine serve what
purpose?
1.
To attach the scales
2.
To adjust the scale length
3.
To make slight angular
adjustments
4.
To align the scale on the
drafting board
2-23.
Which of the following is/are
advantage(s) of the parallel
straightedge?
1.
Ideal use in tight quarters
2.
Simple to adjust and care for
3.
Useable by both left- and
right-handed DMs
4.
Each of the above
2-24.
The most commonly used T-square has
a blade of what length?
1.
15 inches
2.
24 inches
3.
36 inches
4.
42 inches
2-25.
What should you do when a T-square
becomes out of true or damaged?
1.
Hang it up
2.
Tell the LPO
3.
Throw it away
4.
Sand down the edge
2-26.
How should you store a T-square
when you are not using it?
1.
Leave it hanging up
2.
Place it upright in a corner
3.
Place it under the tabletop
4.
Place it on a shelf in a locker
7
